 |
 |
| |
 |
|
 |
 |
 |
For a clear view of your measurement values, we equipped
the display with an EL back light. In addition, we incorporated the
large LCD with 3 display levels allowing more information to be shown
more clearly and with larger sized characters.
As the EL back light is sensor activated, it lights only when ambient
light conditions are low.
Users will be satisfied under many different lighting conditions at
the ease of reading the PT-80 display. |
 |
 |
Collecting and storing measurement data for reports
can be tedious..
For efficient use of measured data, we equipped the PT-U80 with the
ability to Send/Receive data when connected to a PC via USB. Using
imported data for creating reports is easy. With the Preset Report
Form it becomes even easier. Each data setting is also possible on
the PC side.
The software is downloadable from our website. |
 |
 |
| If the laser pointer is shifted off-axis from an actual
measurement center, it is difficult to accurately locate it again
in the same place. To solve this difficulty, the PT-80 is equipped
with a co-axial laser marker which points at the exact center of the
measurement area, independent of working distance. |
 |
 |
Often, measurement from a long distance can be difficult
and sometimes impossible due to a wide measurement area.
The PT-80’s measurement area is 30 x 30 mm from a distance of
1 m. Even from 5 m, its long-focus design still manages an area of
only 150 x 150 mm. So safe and secure measurement is possible even
in difficult to reach or dangerous locations. |
 |
 |
 |
 |
 |
| Checking for hot spots
in an electrical panel. |
|
Checking for abnormal heating in a bearing. |
|
|
|
|
 |
 |
 |
 |
|
|
The exclusive software activates PT-U80 connected Computer*
by USB attached. Please read install manual carefully below
before installing the software. Optex is not responsible for
any troubles in installation.
1) Operation Check
Optex recommends Computer installed Windows 2000 or XP with
USB connector. Minimum 256M is required for the proper function.
USB Rev1.1 conformity. Another software are not identified."
2) Operation may fail dpending on peripheral devices connected
to the Computer.
|
*About software installation |
| Installation
manual |
 |
*The exclusive software download |
| THERMO HUNTER setup.exe |
|
*Software explanation |
| About
continuous recording |
 |
| About
forwarding/adjusting memorized data |
|
| About
teaching |
|
| About each adjustment |
|
|
  |
 |
|
