OPTEX

Contact Entrance site map Japanese
HOME Products About Us Investors Relations Social Activities
HOME > Products > Automatic Door Sensors > Pedestrian Doors > OA-EDGE/EU/T

 

OA-EDGE1/2/EU/T

Safety

The wide detection area of each module secures a high level of safety around the door and will prevent the door leaf fromhitting an object or person near the door. The Optex OA-Edge T is tested and approved by the German test organization TÜV and in compliance with German DIN 18650.

Easy installation

The sensor is easy to install by simply clicking the master and slave modules into the profile, the master and slave modules are connected by a communication cable with connector. Altenative power supply connector on the master module makes installation more flexible and quicker.

Module

The sensor can be assembled using master and slave modules according to the required safety level and the width of the swing door. For a standard configuration of 2 sensors installed on door with a width of 900 mm only one master module is required, a maximum of 3 slave modules can be connected to this master module.

Quick adjustment

Adjustments of the sensor are done by the use of dipswitches and a levelling screw. When the sensor is set up an easy push on the function switch will start the intialization and learning cycle. After installation, sensor status can be easily checked by the visible LED.

OA-EDGE

Product Information

Specification sheet